1
|
LF/FF button
-
Feeds paper line by line when pressed shortly.
-
Ejects a single sheet or advances continuous paper to the next top-of-form position when held down for a few seconds.
|
2
|
Micro Adjust
When you hold down the Pause button for three seconds, the printer enters the Micro Adjust mode. In this mode, you can adjust the top-of-form and tear-off positions by pressing the LF/FF and Load/Eject buttons. See Using the Micro Adjust Function.
|
3
|
Load/Eject button
-
Loads a single sheet of paper.
-
Ejects a single sheet of paper if a sheet is loaded.
-
Loads continuous paper from the standby position.
-
Feeds continuous paper backward to the standby position if a sheet is loaded.
|
4
|
Pause button
-
Stops printing temporarily, and resumes printing when pressed again.
-
When held down for three seconds, enters the Micro Adjust mode. When pressed again, exits the Micro Adjust mode.
|
|
Pause light
-
On when the printer is paused.
-
Flashes when the printer is in the Micro Adjust mode.
|
5
|
Paper out light
-
On when no paper is loaded in the selected paper source or paper is not loaded correctly.
-
Flashes when paper has not been fully ejected.
|
6
|
Power light
-
On when the printer turns on.
-
Flashes when a fatal error occurs.
|