Reference Guide

Index
Search
Glossary
Contents
Help

Control Panel

Buttons and Lights

1

Font button

Selects one of the available fonts. To select a font, see Selecting a Font and Pitch.

Font lights

Indicate which font is selected.

2

Reset

When you press both the Font and Pitch buttons simultaneously, the printer clears buffer and returns to its default settings.

3

Pitch button

Selects one of the pitch settings. To select a pitch, see Selecting a Font and Pitch.

Pitch lights

Indicate which pitch is selected.

4

Tear Off/Special Paper button

  • Feeds continuous paper forward to the tear-off position.

  • Feeds continuous paper backward from the tear-off position to the top-of-form position.

  • Selects special paper (envelope or card) as the paper type.

Tear Off/Special Paper lights

  • Flash when continuous paper is in the tear-off position.

  • Only the right one is on when envelope is selected as the paper type.

  • Only the left one is on when card is selected as the paper type.

5

Paper Source button

Selects a paper source.

Tractor light

On when continuous paper is selected.

Manual/CSF light

On when single-sheet is selected.

6

LF/FF button

  • Feeds paper line by line when pressed shortly.

  • Ejects a single sheet or advances continuous paper to the next top-of-form position when held down for a few seconds.

7

Load/Eject button

  • Loads a single sheet of paper.

  • Ejects a single sheet of paper if a sheet is loaded.

  • Loads continuous paper from the standby position.

  • Feeds continuous paper backward to the standby position if a sheet is loaded.

8

Micro Adjust

When you hold down the Pause button for three seconds, the printer enters the Micro Adjust mode. In this mode, you can adjust the top-of-form and tear-off positions by pressing the LF/FF and Load/Eject buttons. See Using the Micro Adjust Function.

9

Paper out light

  • On when no paper is loaded in the selected paper source or paper is not loaded correctly.

  • Flashes when paper has not been fully ejected or a paper jam has occurred.

10

Pause button

  • Stops printing temporarily, and resumes printing when pressed again.

  • When held down for three seconds, enters the Micro Adjust mode. When pressed again, exits the Micro Adjust mode.

Pause light

  • On when the printer is paused.

  • Flashes when the printer is in the Micro Adjust mode.


[Top]


Next
Version 1.00E, Copyright © 2002, SEIKO EPSON CORPORATION