Online Reference Guide

Index	Search	Glossary

Contents	Help

Advanced Scanning / Using the Preview Window

Specifying Source and Target Image Sizes

The Source fields indicate the size of the image that is displayed or selected in the Preview window.

The Target fields indicate what size the image will be when it is output.

Note:

The Source and Target size settings are closely related to the Resolution setting. If you change these settings arbitrarily, the resulting image may not be what you expect.

Width (W) and height (H) values

The Source and Target width and height values are indicated in the selected unit of measure. You can type new values directly in the indicator fields, or you can change the image area in the Preview window by creating a marquee, or frame. Do this by dragging the mouse over the desired area. See Using a marquee for more information on marquees.

Note:

When the Thumbnail preview is activated, the Source size appears dimmed and is not available.

Units menu

Select a unit of measurement. You can select either inches, pixels, or cm.

Storage size indicator

The storage size of an image is indicated in KB or MB. As you change the image area in the Preview window, this value also changes.

Lock button

locked

unlocked

The current size of width-to-height of the target image can be locked, allowing the ratio of width-to-height of the Source image to change according to the scale value, or the scale value to change according to the ratio of width-to-height of the Source image. This is especially useful in cases where the size of an image does not fit the size of the paper on which you want to print the image, but you want to keep the image's original proportions. Enter the size of the paper in the Width and Height fields of the Target box and then click the Lock button. The scale value is automatically changed, maintaining the current ratio of width-to-height to fit the paper.

Note:

When the Thumbnail preview is activated, the Lock button appears dimmed and is not available.

Scale slider

An image can be reduced or enlarged by moving the Scale slider. You can also click the left or right arrow to change the image size in 1% increments.

The range of possible reduction or enlargement varies depending on the current resolution setting.

Scale indicator

The percentage of enlargement or reduction is shown in the Scale indicator field. You can type a new value directly into this field, or use the Scale slider to determine the value.

[Top]