The EPSON Network Image Express Card (B808392) lets you use your scanner over a network without having to connect the scanner to a server PC.

For details on using the card, see the documentation that came with it.

Caution:

Do not install any other optional card in your scanner, or you may damage your scanner. To use the Network Image Express Card, disconnect the USB cable from the scanner; otherwise the scanner may not work properly. Do not connect the USB cable while an Ethernet cable is already connected to the RJ-45 connector on the Network Image Express Card.

Turn off the scanner.

Caution:

Do not install or uninstall the Network Image Express Card while the scanner is turned on; otherwise damage may occur.

Unplug the power cord and disconnect all the cables from your scanner. (Do not disconnect the cable securing the ADF to your scanner.)

Remove the two screws securing the shield plate using a Phillips-head screwdriver, then remove the shield plate. Be sure to keep the screws in case you re-install the shield plate later.

Insert the Network Image Express Card in your scanner’s optional interface slot.

Press in as you tighten the thumbscrews to secure the card.

Plug the scanner’s power cord into an electrical outlet.

To initialize the Network Image Express Card, turn on the scanner while holding down the Reset button on the card for 10 seconds. The red status light and green data light come on.

Note:

Be sure to initialize the Network Image Express Card whenever you install or re-install it in the scanner.

Turn off the scanner.