|
|
|
|||||||||||||||||||||||||||||||||
Technical Specifications
The scanner can be initialized (returned to a fixed set of conditions) in the following ways:
|
Hardware initialization |
The scanner is turned on. The scanner receives a SCSI Reset signal from the SCSI interface. |
|
Software initialization |
Software sends the ESC @ (initialize the scanner) command. The scanner receives a SCSI Bus Device Message. |
|
Hardware initialization |
The scanner is turned on. The USB cable is unplugged from the USB port on the scanner. |
|
Software initialization |
Software sends the ESC @ (initialize the scanner) command. The scanner receives a Bus Reset from the USB interface. |
 Previous |
 Next |
| Version 1.00E, Copyright © 2001, SEIKO EPSON CORPORATION |
