 |
 |
|
||
 |
||||
Installing the Transparency Unit
Follow the steps below to install the Transparency Unit.
 |
Make sure the scanner is turned off, and then unplug the power cord from the scanner.
|
 |
Open the scanner’s document cover, and then remove it by lifting the cover straight up.
|
 |
Align the pins of the unit with the holes of the scanner, and then lower the unit until it rests securely on the scanner with the pins in the holes.
|
 |
Remove the reflective document mat from the Transparency Unit as shown below.
|
 |
Place the transparency guide on the scanner’s document table as shown below.
|
 |
Close the Transparency Unit.
|
 |
Connect the Transparency Unit’s connector to the option connector at the back of the scanner.
|
 |
Connect the power cord to the scanner and then turn on the scanner.
|
Important:|
Do not put heavy objects on the Transparency Unit; otherwise the unit may be damaged.
|
To scan slides or strips of negative or positive films, see the following section.