Home > Using the Network Interface Panel

Setting Up Client Computers with Epson Scan Settings

Make sure your scanner and Network Interface Panel are turned on and working properly. Then follow the steps below to use the Epson Scan Settings program to enable network scanning.

Note for Windows:

Log in as a user with administrator's authority, and then install. If you are asked to enter an administrator's password, enter the password, and then continue with the operations.

Note for Mac OS X:

Do not use the Fast User Switching function while using your scanner.

You must log on to a Computer Administrator account.

Obtain the IP address or host name of the Network Interface Panel from your network administrator.

Start Epson Scan Settings.

Windows:
Start > All Programs or Programs > EPSON > EPSON Scan > EPSON Scan Settings

Mac OS X:
Select Applications > EPSON Software > EPSON Scan Settings.

Select your scanner from the Select Scanner drop-down list.

Select Network, then click Add.

In the Add window, choose the Network Interface Panel’s IP address under Search for addresses, or select Enter address and type in the address. Then click OK.

In the Epson Scan Settings window, click Test to check the connection. If everything works properly, you see a successful connection message appears.

Click OK to save the settings.