Reference Guide
|
|
Safety Information
Safety Precautions
Be sure to follow these precautions carefully to ensure safe, efficient operation:
-
Because the printer weighs approximately 50 kg (110 lb), you should not lift or carry it by yourself. Two or more people should carry it, lifting it by the correct positions as shown below. Follow the instructions in the Unpacking Guide carefully.
|
|
left side
|
right side
|
-
Do not touch the areas specified on the caution labels inside cover A. If the printer has been in use, these areas can be very hot.
1.
|
CAUTION Hot Surface Avoid Contact
|
-
Do not touch the components inside the printer unless instructed to do so in this guide.
-
Never force the printer's components into place. Although the printer is designed to be sturdy, rough handling can damage it.
-
Do not turn the cartridge upside down or stand it on its sides.
-
Protect the light-sensitive drum from exposure to light. Avoid exposing the Imaging Cartridge to room light any longer than necessary. Do not open the drum's protective cover. Overexposing the drum may cause abnormally dark or light areas to appear on the printed page and reduce the service life of the drum.
-
When handling the cartridge, always set it on a clean, smooth surface.
-
Do not attempt to modify or take apart the cartridge. It cannot be refilled.
-
Do not touch the toner and avoid all contact with your eyes.
-
Wait for at least one hour before using a cartridge after moving it from a cool to a warm environment.
|
Warning:
|
|
Do not dispose of used Imaging Cartridges in fire, as they can explode and cause injury. Dispose of them according to local regulations.
|
To get the best print quality, do not store the Imaging Cartridge in an area subject to direct sunlight, dust, salty air, or corrosive gasses (such as ammonia). Avoid locations subject to high temperatures, humidity, or abrupt changes in temperature or humidity. Also, be sure to keep the consumable components out of the reach of children.
|
Hinweis:
|
|
Die Geräteanschlußleitung muß den einshlägigen Normen genügen. Es muß eine dreiadrige Leitung verwendet werden. Die Anshlußleitung darf nicht leichter als H05VV-F order H05VVH2-F sein.
|
|
Maschinenlärminformations-Verordnung-3. GSGV, 18. 01. 1991: Der arbeitsplatzbezogene schalldruckpegel beträgt 70 dB (A) oder weniger gemäß ISO 7779.
|
[Top]
|
Version 1.00E, Copyright © 2002, SEIKO EPSON CORPORATION |