Reference Guide
|
|
Setup & Maintenance / Installing Options
Interface Cards
Your printer comes with a Type B interface slot. Various optional interface cards are available to expand your printer's interface options.
Follow these steps to install an optional interface card.
|
Caution:
|
|
Before you install the interface card, be sure to discharge any static electricity by touching a grounded piece of metal. Otherwise, you may damage static-sensitive components.
|
|
|
Turn the printer off and unplug the power cord and interface cable.
|
|
Remove the screws and the Type B interface card slot cover as shown below.
|
| |
Warning:
|
| |
Removing screws and covers that are not described in the following instructions will expose high voltage areas.
|
|
| |
Note:
|
| |
Keep the slot cover in a safe place. You will need to reattach it if you remove the interface card later.
|
|
|
Slide and push the interface card into the slot firmly, then fasten the screw as shown below.
|
|
Reconnect the interface cable and power cord and turn the printer on.
|
Removing an interface card
Perform the installation procedure in reverse.
[Top]
Version NPD0274-00, Copyright © 2003, SEIKO EPSON CORPORATION |