Network Guide
|
|
Tips for Administrator
Instructions on Using a Dial-Up Router
This section describes instructions on using a dial-up router.
If DHCP is used to assign an IP address of the printer and the Dynamic DNS function is not supported, you need to change the printer port setting every time you turn on the printer. Therefore, we recommend that you set a valid IP address for the print server by using the one of the following methods.
-
Set the IP address for the print server manually. Use EpsonNet WinAssist or MacAssist. See TCP/IP or TCP/IP.
-
Specify the print server by using the bind of DHCP function.
-
Set the exclusive address of the DHCP function.
|
Note:
|
| -
Use NetBEUI printing if you do not want to go through these steps.
|
|
| -
See the manual of the Dial-Up router for more information on scorp range, bind, exclusive address of the DHCP function.
|
|
[Top]
Version NPD0133-03, Copyright © 2003, SEIKO EPSON CORPORATION |