![](FILES/01.GIF) |
Handling precautions
Replacing an imaging cartridge
Always observe the following handling precautions when replacing the consumable products:
![](FILES/01.GIF) | ![](FILES/MARK_WA.GIF) |
Warning: |
![](FILES/01.GIF) | ![](FILES/01.GIF) |
-
If toner is spilled, use a broom and dustpan or a damp cloth with soap and water to clean it up. Because the fine particles can cause a fire or explosion if they come into contact with a spark, do not use a vacuum cleaner.
|
|
Replacing an imaging cartridge
Follow the steps below to replace an imaging cartridge.
![](FILES/STEP_1.GIF) |
Open the printer’s front cover by placing your fingers on the grooves on both sides of the cover as shown below, and then pull it towards you.
|
![](FILES/STEP_2.GIF) |
Open top cover.
|
![](FILES/STEP_3.GIF) |
Remove the imaging cartridge from the printer.
|
![](FILES/01.GIF) | ![](FILES/MARK_NO.GIF) |
Note: |
![](FILES/01.GIF) | ![](FILES/01.GIF) |
Be careful not to touch the transfer roller.
|
|
![](FILES/STEP_4.GIF) |
Take the new imaging cartridge out of its package and gently shake the imaging cartridge as shown below.
|
![](FILES/STEP_5.GIF) |
Hold the tag and gently pull the toner seal upward and remove it.
|
![](FILES/STEP_6.GIF) |
Insert the imaging cartridge carefully so that it does not bump any components inside the printer.
|
![](FILES/01.GIF) | ![](FILES/MARK_NO.GIF) |
Note: |
![](FILES/01.GIF) | ![](FILES/01.GIF) |
Be careful not to touch the transfer roller.
|
|
![](FILES/STEP_7.GIF) |
Close top cover.
|
![](FILES/STEP_8.GIF) |
Close front cover.
|
| ![](FILES/01.GIF) |