Reference Guide

Index Search Glossary Contents Help

Safety Information

Safety Precautions

Read all of these instructions and save them for later reference.

• Follow all warnings and instructions marked on the copy station.

• Do not place the product on an unstable surface or near a radiator or heat source.

• Place the product on a flat surface. The product will not operate properly if it is tilted or at an angle.

• Before moving the copy station, unplug the scanner and printer and remove them from the cabinet.

• Do not block or cover the openings in the printer or the scanner.

• Do not insert objects through the slots in the printer or the scanner.

• Use only the type of power source indicated on the printer and scanner labels.

• Connect all equipment to properly grounded power outlets. Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off.

• Do not use a damaged or frayed power cord.

• If you use an extension cord with the copy station, make sure the total ampere rating of all devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the total of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating.

• Unplug the product before cleaning, and clean it with a damp cloth only.

• Do not spill liquid on the copy station.

• Unless otherwise explained in this guide, do not attempt to service this product yourself.

• Unplug the copy station and refer servicing to qualified service personnel under the following conditions:

If a power cord or plug is damaged; if liquid has entered the copy station; if any copy station component has been dropped or the cabinet damaged; or if the copy station does not operate normally or exhibits a distinct change in performance. Adjust only those controls that are covered by the operating instructions.

• For European users:

Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

[Top]

Next