The power cord may not be properly plugged into the electrical outlet.

Turn off the printer, check the power cord connections between the printer and the electrical outlet, then turn the printer back on.

The electrical outlet may be controlled by an outside switch or an automatic timer.

Make sure that the switch is turned on or plug another electrical device into the outlet to check whether the outlet is operating properly.

The printer is offline.

Press the  Start/Stop button once to switch the printer to ready status.

Some error may have occurred.

Check the LCD panel to see if an error message appears.

Your computer may not be properly connected to the printer.

Perform the procedure described in “Connecting the Printer to a Computer” in the Setup Guide.

The interface cable may not be plugged in securely.

Check both ends of the interface cable between the printer and the computer. If you are using the parallel interface, be sure to secure the connector using the wire retaining clips.

You may not be using the correct interface cable.

If you are using the parallel interface, make sure that the cable is a double-shielded, twisted-pair interface cable no more than six feet in length.

If you are using the USB interface, use a Revision 2.0 cable.

Your application software is not properly set up for your printer.

Make sure that the printer is selected in your application software.

Your computer system’s memory is too small to handle the volume of data in your document.

Try reducing the image resolution of your document in the application software, or install more memory in your computer if you can.

For Windows users, EPSON Status Monitor is not installed.
For Macintosh users, you do not re-register the printer.

For Windows users:
You have to make settings manually in the printer driver. See Making Optional Settings.

For Macintosh users:
When you have attached or removed printer options, you need to delete the printer using Print Setup Utility (for Mac OS X 10.3), Print Center (for Mac OS X 10.2 or below), or Chooser (for Mac OS 9), and then re-register the printer.