Handling precautions
Replacing the transfer unit

Always observe the following handling precautions when replacing the consumable products.

Do not touch the surface of the consumable product. Doing so may impair print quality.

Warning:

Do not dispose of the used consumable products in fire, as it may explode and cause injury. Dispose of it according to local regulations. Keep the consumable products out of the reach of children.

Top

Follow the steps below to replace the transfer unit.

Press the latch on cover A and open the cover.

Grasp the two orange tabs and pull them up.

Pull the transfer unit out of the printer.

Warning:

Be careful not to touch the fuser, which is marked CAUTION HIGH TEMPERATURE, or the surrounding areas. If the printer has been in use, the fuser and the surrounding areas may be very hot.

Take the new transfer unit from its package.

Hold the new transfer unit by the orange tabs and lower it so the arrow on the transfer unit and the arrow inside the printer line up. Make sure the posts of the transfer unit fit into the guides.

Pull the transfer unit toward you and push the orange tabs into place.

Warning:

Be careful not to touch the fuser, which is marked CAUTION HIGH TEMPERATURE, or the surrounding areas. If the printer has been in use, the fuser and the surrounding areas may be very hot.

Close cover A.

Top