|
 Handling precautions
Replacing the fuser unit
Always observe the following handling precautions when replacing the consumable products.
Do not touch the surface of the consumable product. Doing so may impair print quality.
 |
Warning: |
Follow the steps below to replace the fuser unit.
 |
Turn off the printer, and wait for 30 minutes until the temperature has subsided.
|
 |
Press the latch on cover B and open the cover.
|
 |
Unlock the lock levers on both sides of the fuser unit.
|
 |
Lift the fuser unit out of the printer as shown below.
|
 |
Take the new fuser unit out of its package.
|
 |
Hold the new fuser unit by the handles and lower it into the printer making sure that the posts on the unit slide into the notches of the lock levers.
|
 |
Push in on both sides of the fuser unit until the lock levers get to the lock positions.
|
 |  |
Note: |
| |
|
Make sure that the lock levers are completely back to the locked position marked Lock.
|
|
 |
Close cover B.
|
| 
Top