This section describes instructions on using a dial-up router.

If DHCP is used to assign an IP address of the printer and the Dynamic DNS function is not supported, you need to change the printer port setting every time you turn on the printer. Therefore, we recommend that you set a valid IP address for the network interface by using the one of the following methods.

• Set the IP address for the network interface manually. Use EpsonNet Config. See the EpsonNet Config Reference Guide for details.

• Specify the network interface by using the bind of DHCP function.

• Set the exclusive address of the DHCP function.

Note:

Use NetBEUI printing if you do not want to go through these steps. See the manual of the Dial-Up router for more information on scorp range, bind, exclusive address of the DHCP function.