Network Guide

Index	Search	Safety

Contents	Help

How To / How to Set Up the Print Server

Connecting the Print Server to the Network

Follow the instructions below to connect the print server to the network.

Make sure that your printer is turned off.

Connect one end of the network cable to the RJ-45 connector on the print server, and the other end to the network.

Caution:

You must use a Category 5 shielded twisted-pair cable to connect the print server to prevent malfunction.

Do not connect or disconnect the network cable when the printer is on.

Do not connect the print server and the computer directly. Be sure to use a HUB to connect the print server to the network.

Note:

You can use both 10Base-T and 100Base-TX. When you print a lot of data, we recommend you use a high-speed network of 100Base-TX with a light network traffic.

Turn on your printer. After the status lights go off, print a network status sheet.

Caution:

After turning off the printer, wait until the status lights go off before turning it back on; otherwise the print server may not work correctly.

Note for Mac OS X 2.4:

Since the printer supports Rendezvous and is on by default, you can use the printer on a network just by connecting it to the network. If you want to disable the Rendezvous setting, use the printer's control panel. See Setting an IP Address on the Printer's Control Panel for details.

Now, you can configure the print server for the network, using EpsonNet WinAssist/MacAssist. Go to Installing EpsonNet WinAssist/MacAssist.

[Top]