P5C Emulation Kit

Installing the P5C ROM module
Removing the P5C ROM module

The P5C Emulation kit is available as an option for this printer. This module allows your printer to print documents in the PCL5c printing language.

Installing the P5C ROM module

Follow the steps below to install the P5C ROM module.

Caution:

Before you install the ROM module, be sure to discharge any static electricity by touching a grounded piece of metal. Otherwise, you may damage static-sensitive components.

Warning:

Be careful when working inside the printer as some components are sharp and may cause injury.

Turn the printer off and unplug the power cord and interface cable.

Remove the four screws from the cover on the back side of the printer.

Hold the cover with both hands and pull it toward you to remove it.

Warning:

Be careful when touching the circuit board inside the back side cover since some parts may be very hot.

Identify the ROM module slots.

Note:

The standard ROM module, which should not be removed, is inserted in one of the slots.

Insert the ROM module horizontally into the slot until the clip comes out.

Caution:

Do not force the ROM module into the socket. Be sure to insert the ROM module in the correct direction. Never remove the ROM module installed on the standard ROM socket (P).

Reattach the cover to the back side of the printer and secure it with the four screws.

Reconnect the power cord and turn the printer on.

To confirm that the option is installed correctly, print a Status Sheet. See Printing a Status Sheet.

If P5C is not listed as an installed emulation on the status sheet, try reinstalling the module. Make sure that it is securely seated into the ROM slot on the circuit board.

Top

Removing the P5C ROM module

Caution:

Before you remove the ROM module, be sure to discharge any static electricity by touching a grounded piece of metal. Otherwise, you may damage static-sensitive components.

Warning:

Be careful when working inside the printer as some components are sharp and may cause injury.

Turn off the printer and perform the installation procedure in reverse.

Top