 |
 | Replacement Messages |
|
When you see the following messages on the LCD panel or the window of EPSON Status Monitor 3, replace the appropriate consumable products. You can continue to print for a short time after a message appears, but Epson recommends early replacement to maintain print quality and extend the life of your printer.
|
LCD Panel Message
|
Description
|
|
Worn Photoconductor
|
The photoconductor unit has reached the end of its service life.
|
|
Worn Fuser
|
The fuser unit has reached the end of its service life.
|
|
Worn Transfer Unit
|
The transfer unit is near the end of its service life.
|
 |
Note: |
|
|
To clear the warning, select Clear All Warning from the control panel’s Reset Menu.
|
|
If a consumable product reaches the end of its service life, the printer stops printing and displays the following messages on the LCD panel or the window of EPSON Status Monitor 3. When this happens, the printer cannot resume printing until you replace the depleted consumable products.
|
LCD Panel Message
|
Description
|
|
Replace Toner uuuu*
|
The indicated toner cartridges are empty.
|
|
Replace Photoconductor
|
Printing has stopped to avoid damage to the engine.
|
|
Replace Waste T Box
|
The waste toner collector is full.
|
* The letters C, M, Y, or K appear in this position, indicating the color of the toner to be replaced. For example, the message Y Toner Low means that the amount of toner remaining in the yellow toner cartridge is low.
|
Note: |
|
|
Messages appear for one consumable product at a time. After replacing a consumable product, check the LCD panel for replacement messages for other consumable products.
|
|
Even if Replace Toner uuuu or Replace Photoconductor is displayed on the LCD panel, you can print an additional sheets by pressing the  Start/Stop button on the control panel. The message on the LCD panel changes from Replace Toner uuuu or Replace Photocondctor to uuuu Toner Low or Worn Photoconductor.
|
Note: |
| |
