Reference Guide

Index	Search	Glossary

Contents	Help

How To / Installing Options

Adobe PostScript 3 ROM Module

Follow these steps to install the optional Adobe PostScript 3 ROM module.

Warning:

Be careful when working inside the printer as some components are sharp and may cause injury.

Caution:

Before you install the ROM module, be sure to discharge any static electricity by touching a grounded piece of metal. Otherwise, you may damage static-sensitive components.

Note:

The optional ROM modules that expand your printer's features differ, depending on the country of purchase.

The Adobe PostScript 3 ROM Module cannot be used for a Macintosh connected with the IEEE 1394 Type B Interface Card.

Turn the printer off and unplug the power cord.

Prepare the printer as shown below.

Identify the ROM slots.

1. ROM slots

Insert the module firmly into the slot, as shown below.

Caution:

Do not force the ROM module into the slot.

Be sure to insert the module facing the correct way.

You should not remove any modules from the circuit board. Otherwise, the printer will not work.

Return the printer to its original state as shown below.

Plug the printer's power cord into an electrical outlet.

Turn on the printer.

To confirm that the option is installed correctly, print a status sheet. See Printing a Status Sheet.

Removing the Adobe PostScript 3 ROM module

Perform the installation procedure in reverse.

[Top]