|
Setting an IP Address on the Printer’s Control Panel (Large Format Inkjet Printers)
Network Setup Menu
After connecting the printer to the network, you need to set the IP address for the network interface.
To set the IP address, subnet mask, and default gateway from the control panel, follow the steps below.
|
Turn on your printer.
|
|
Press the Right button on the printer's control panel once to display MENU.
|
|
Press the Down button until NETWORK SETUP appears. Then press the Right button.
|
|
Select NETWORK SETUP, then press the Right button.
|
|
Select ENABLE, then press the Enter button to enable the network settings menu.
|
|
Press the Left button to display the NETWORK SETUP menu.
|
|
Press the Down button to select IP ADDRESS SETTING, then press the Right button. You can use the following methods to get an IP address.
|
| |
Note: |
|
Select PANEL, then press the Enter button. Press the Left button to return to the NETWORK SETUP menu.
|
|
Press the Down button to select IP, SM, or GW, then press the Right button.
|
|
Press the Up or Down button on the IP ADDRESS screen until the desired value appears. Then press the Right button.
|
|
Press the Up or Down button on the SUBNET MASK screen until the desired value appears. Then press the Enter button.
|
|
Press the Up or Down button on the DEFAULT GATEWAY screen until the desired value appears. Then press the Enter button to set the values.
|
|
Press the Left button twice to exit the control panel menus.
|
|
Turn off your printer and then turn it back on. Be sure to wait until the initialization is complete.
|
Print a network status sheet to confirm the new IP address.
|
Note: |
These items are used to make network settings on the printer’s control panel.
Item
|
Settings (default in bold)
|
NETWORK SETUP
|
Disable, Enable
|
IP ADDRESS SETTING*
|
Auto, Panel, PING
|
IP*
|
0.0.0.0 to 255.255.255.255
|
SM*
|
0.0.0.0 to 255.255.255.255
|
GW*
|
0.0.0.0 to 255.255.255.255
|
AppleTalk*
|
On, Off
|
MS Network*
|
On, Off
|
Bonjour*
|
On, Off
|
INIT NETWORK SETTING*
|
EXECUTE
|
* Available only when Enable is selected for NETWORK SETUP.
| |