![](files/01.gif) |
Follow these steps to load paper:
![](files/step_1.gif) |
Open the paper support, then slide out the extension.
|
![](files/step_2.gif) |
Open the front cover, then slide out the front tray.
|
Make sure the front tray is in the paper position (lower position). If it is not, move the tray lever up and reposition the front tray.
![](files/01.gif) | ![](files/mark_ca.gif) |
Caution |
![](files/01.gif) | ![](files/mark_no.gif) |
Note: |
![](files/01.gif) | ![](files/01.gif) |
Before you move the tray lever, make sure no paper or other objects are on the front tray and the front tray is not extended.
|
|
![](files/step_3.gif) |
Slide the edge guide to the left.
|
![](files/step_4.gif) |
Fan a stack of paper, then tap it on a flat surface to even the edges.
|
![](files/step_5.gif) |
Load the paper with the printable side up, against the right side of the sheet feeder. Then slide the left edge guide against the left edge of the paper, but not too tightly.
|
![](files/01.gif) | ![](files/mark_no.gif) |
Note: |
| ![](files/01.gif) |