![](files/01.gif) |
Follow these steps to load envelopes:
![](files/step_1.gif) |
Open the paper support, then raise the extension.
|
![](files/step_2.gif) |
Lower the output tray, then slide out the extension.
|
![](files/step_3.gif) |
Slide the left edge guide to the left.
|
![](files/step_4.gif) |
Load envelopes short edge first with the flap side down and on the left:
|
![](files/step_5.gif) |
Set the paper thickness lever to the position.
|
![](files/01.gif) | ![](files/mark_no.gif) |
Note: |
For printing instructions, see the following instructions.
See Printing on Envelopes
| ![](files/01.gif) |