Reference Guide

Index
Search
Glossary
Contents
Help
Safety

Problem Solver / Driver Installation Problems

Setup for Mac OS 9

It is necessary to select the printer driver for the printer in the Chooser before printing. Follow the steps below to select the printer driver.

Note
  • Once you have selected the printer driver in the Chooser, you do not need to add it again unless you change printer drivers.
  • Ensure you have securely connected the printer to your computer using the interface cable, then turn on the printer.

Click on the printer in the Chooser, and select an appropriate port. Refer to the following table for port selection.

Connection Type

Selection

USB cable

Select USB

IEEE 1394 cable

* IEEE 1394-supported model only

Select EPSON Fire Wire

Note
If the USB port is not displayed, make sure the printer has been turned on and securely connected to your computer using the interface cable.

Click the button in the upper left corner of the screen to close it.


[Top]


Previous

Next
Version NPD1082-00, Copyright © 2005, SEIKO EPSON CORPORATION