Reference Guide
|
|
Product Information / Safety Instructions
Important Safety Instructions
Read all of these instructions before using your printer. Also, be sure to follow all warnings and instructions marked on the printer.
-
Do not block or cover the openings in the printer's cabinet. Do not insert objects through the slots.
-
Take care not to spill liquid on the printer.
-
Use only the type of power source indicated on the printer's label.
-
Connect all equipment to properly grounded power outlets. Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off.
-
Avoid electrical outlets controlled by wall switches or automatic timers.
-
Keep the entire computer system away from potential sources of electromagnetic interference, such as loudspeakers or the base units of cordless telephones.
-
Do not use a damaged or frayed power cord.
-
If you use an extension cord with the printer, make sure the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating.
-
Do not attempt to service the printer yourself.
-
Unplug the printer and refer servicing to qualified service personnel under the following conditions:
The power cord or plug is damaged; liquid has entered the printer; the printer has been dropped or the cabinet damaged; the printer does not operate normally or exhibits a distinct change in performance.
-
If you use the printer in Germany, observe the following:
To provide adequate short-circuit protection and over-current protection for this printer, the building installation must be protected by a 16 Amp circuit breaker.
Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit einem 16 A-Überstromschalter abgesichert ist.
[Top]
Version 1.00E, Copyright © 2002, SEIKO EPSON CORPORATION |