If you need to transport your printer some distance, carefully prepare and repack it as described below. Use the original box and packing materials, or a similar box that holds the printer snugly.

Caution:

When storing or transporting the printer, do not tilt it, stand it up vertically, or turn it upside down. Otherwise, ink may leak from the cartridges. Leave the ink cartridges installed. Removing the cartridges can dehydrate the print head and may prevent the printer from printing.

Plug in the printer and turn it on. Wait until the print head returns to the home position, then close the printer cover.

Turn off the printer and unplug its power cord.

Disconnect the interface cable.

Remove all paper from the sheet feeder.

Open the printer cover. Secure the ink cartridge holder with tape, as shown below, then close the printer cover.

Make sure you do not to tape over the ribbon cable.

Remove the output tray and paper support.

Attach the protective materials to both sides of the printer.

Repack the printer and power cord in the original box.

Note:

Keep the printer level during transport. Be sure to remove the protective materials and tape from the printer before using it again.