Read all of the instructions in this section before replacing the photo cartridge.

• This printer uses the photo cartridge equipped with an IC chip that accurately monitors the amount of ink . Even if a cartridge is removed and then later inserted again, all of its ink can be used. However, some ink is consumed each time the cartridge is inserted because the printer automatically checks its reliability.

• If you need to remove the photo cartridge temporarily, be sure to protect the ink supply area from dirt and dust. Store the photo cartridge in the same environment as the printer. When storing the cartridge, be sure that its label is facing upward. Do not store the photo cartridge upside down.

• The valve in the ink supply port is designed to contain any excess ink that may be released. However, careful handling is recommended. Do not touch the supply port of the photo cartridge or its surrounding area.

• Ink is consumed during the following operations: print head cleaning, and self-cleaning cycle performed when the printer is turned on.

• Do not refill the photo cartridges. Refilled cartridges are not monitored by the IC chip. In addition, refilled cartridges may not print clearly or effectively.

• Keep photo cartridges out of the reach of children. Do not allow children to drink from or otherwise handle the cartridges.

• Be careful when you handle used photo cartridges, as there may be some ink around the ink supply port. If ink gets on your skin, wash the area thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. If discomfort or vision problems continue after a thorough flushing, see a doctor immediately.

• Epson recommends the use of genuine Epson photo cartridges. Other products not manufactured by Epson may cause damage that is not covered by Epson's warranties, and under certain circumstances, may cause erratic printer behavior.

• Leave the old cartridge installed in the printer until you have obtained a replacement; otherwise, ink remaining in the print head nozzles may dry out.