User's Guide

Index Search Contents Help Safety

Other Information

Loading Paper

Follow these steps to load PictureMate Photo Paper:

Caution:

Do not load plain paper; this may damage PictureMate.

Move the handle to the back and down. Then open the paper support and output tray.

Note:

Keep the handle all the way down when printing, to allow paper to feed through.

Slide the top part of the paper support up gently until it clicks into place.

Place your paper against the right edge, with the glossy side up.

Note:

Make sure paper is glossy side up to prevent smearing.

Slide the left edge guide against the paper. Make sure it is snug, but not so tight that paper can't move.

Note:

Do not touch or allow anything to come into contact with the printed side of paper with a shiny finish. After printing on media, allow the ink to set for a few hours before handling them.

Leave enough space in front of the printer for the paper to be fully ejected.

Make sure that the paper stack is flush with or lower than the triangular load-limit mark on the edge guide.

[Top]

Previous

Next