EPSON

Loading Paper

Follow these steps to load paper:
Note:
The illustrations in this section may vary depending on the product.
Slide out the paper support and the output tray and then raise the stopper.
Note:
When using Legal size paper, lower the stopper (*).
Slide the edge guide to the left.
Fan a stack of paper, then tap it on a flat surface to even the edges.
Load the paper with the printable side up, against the right side of the sheet feeder. The printable side is usually whiter or glossier than the other side.
Note:
Always load paper into the sheet feeder short edge first, even when you are printing landscape-oriented pictures.
Slide the edge guide against the left edge of the paper, but not too tightly.
Note:
Leave enough space in front of the printer for the paper to be fully ejected.
For plain paper, do not load paper above the  arrow mark inside the edge guide.
For Epson special media, make sure the number of sheets is less than the limit specified for the media.