 |
 |
|
||
 |
||||
Loading Envelopes
Follow these steps to load envelopes:
 |
Pull out the paper cassette and remove the cover.
|
Note:|
If the output tray has been ejected, close it before pulling out the paper cassette.
 If the paper cassette is in the storage position, extend the paper cassette as shown in the illustration.
 |
 |
Slide the edge guides to the sides of the paper cassette.
|
 |
Load envelopes lengthwise with the flap facing up.
|
Note:|
Make sure the number of envelopes does not exceed the limit specified for the type of media you are using.
|
 |
Slide the edge guides to the edges of the envelopes and check that the envelopes are not sticking out from the end of the cassette.
|
Note:|
Even if you do not feel a click, slide the edge guides to the edges of the envelopes.
|
 |
Put the paper cassette cover back on. Keep the cassette flat and slowly and carefully reinsert it all the way into the printer.
|
 |
Lower the output tray, slide out the extension, and then raise the stopper.
|
Note:|
The thickness of envelopes and their ability to fold vary widely. If the total thickness of the stack of envelopes exceeds 10mm, press down on the envelopes to flatten them before loading. If print quality declines when a stack of envelopes is loaded, load one envelope at a time.
Do not use envelopes that are curled or folded.
Flatten the envelope flaps before loading.
Flatten the leading edge of the envelope before loading.
Avoid using envelopes that are too thin, as they may curl during printing.
Align the edges of the envelopes before loading.
|