 |
 |
|
||
 |
||||
Loading Paper
Follow these steps to load paper:
 |
Open the paper support, then slide out the extension.
|
 |
Open the output tray, then slide out the extension.
|
 |
Slide the edge guide to the left.
|
 |
Fan a stack of paper, then tap it on a flat surface to even the edges.
|
 |
Load the paper with the printable side up, against the right side of the sheet feeder. Then slide the left edge guide against the left edge of the paper, but not too tightly.
|
During printing the left edge guide automatically moves 3 mm to the left. Do not move it back manually.
Note:|
Leave enough space in front of the printer for the paper to be fully ejected.
For plain paper, do not load paper above the
 arrow mark inside the edge guide.For Epson special media, make sure the number of sheets is less than the limit specified for the media. Do not use paper with binder holes.
Always load paper into the sheet feeder short edge first, even when you are printing landscape-oriented pictures.
|