EPSON

Setting Up the Auto Duplexer

Note:
The illustrations in this section show the PX820FWD/TX820FWD/Artisan 835.

Attaching the Auto Duplexer

Turn off the printer.
Remove the rear cover by squeezing the hook on the right side.
Note:
Your printer may not have a rear cover depending on the location of purchase.
Insert the both sides of the connector of the Auto Duplexer along the slits of the printer.
Holding the buttons on the sides, horizontally insert the Auto Duplexer into place.

Removing the Auto Duplexer

Turn off the printer.
Note:
If you are removing the Auto Duplexer to remove jammed paper, do not turn off the printer.
Remove the Auto Duplexer by pressing the buttons on the sides.
Attach the rear cover that you removed when you attached the Auto Duplexer.
Note:
Your printer may not have a rear cover depending on the location of purchase.