|
Reference Guide
|
|
Options and Consumables
Replacing the Ribbon Cartridge
When printing becomes too faint, you need to replace the ribbon. Use the S015384 Epson replacement cartridge only.
 |
Warning:
|
 | |
If the printer has been used recently, the print head may be hot. Let it cool before attempting to replace the ribbon.
|
|
To replace the ribbon cartridge, follow these steps:
 |
Press the Pause button. Then turn off the printer.
|
 |
Open the upper cover and slide the print head to the  mark.
|
 |
Lift the ribbon guide off the print head as shown below.
|
 |
Pull up on the side of the ribbon cartridge as shown below to release it from the printer's mounting pins. Remove the cartridge by lifting it up and away from you.
|
|  |
Caution:
|
| | |
Make sure you don't pull on the flat white cable beneath the ribbon cartridge.
|
|
 |
Remove the separator from the middle of the ribbon cartridge and discard it.
|
* separator
 |
Hold the ribbon cartridge with both hands and lower it into the printer as shown below. Pulling the cartridge toward you, slide the notches nearest you over the two corresponding pins in the printer.
|
 |
Push the cartridge down into position until the other two slots snap into place over the mounting pins in the printer.
|
 |
Press lightly on both sides of the cartridge to make sure it is locked in place.
|
 |
Insert the ribbon guide over the metal pins on each side of the print head as shown below. The smaller end of the guide should be on top, with its angled edge facing back toward the platen. Turn the ribbon-tightening knob again to remove any slack in the ribbon.
|
* ribbon guide
 |
Slide the print head from side to side to see that it moves smoothly and that the ribbon is not twisted or creased.
|
* print head
 |
Close the top cover.
|
[Top]
| Version NPD1014-01, Copyright © 2005, SEIKO EPSON CORPORATION |
